kvr13lse9s8/4 4gb 1rx8 512m x 72-bit pc3l-10600 cl9 204-pin ecc sodimm description this document describes valueram's 512m x 72-bit (4gb) ddr3l-1333 cl9 sdram (synchronous dram), 1rx8, ecc, low voltage, memory module, based on nine 512m x 8-bit fbga components. the spd is programmed to jedec standard latency ddr3-1333 timing of 9-9-9 at 1.35v or 1.5v. this 204- pin sodimm uses gold contact fingers. the electrical and mechanical specifications are as follows: features ? jedec standard 1.35v (1.28v ~ 1.45v) and 1.5v (1.425v ~ 1.575v) power supply ? vddq = 1.35v (1.28v ~ 1.45v) and 1.5v (1.425v ~ 1.575v) ? 667mhz fck for 1333mb/sec/pin ? 8 independent internal bank ? programmable cas latency: 9, 8, 7, 6 ? programmable additive latency: 0, cl - 2, or cl - 1 clock ? 8-bit pre-fetch ? burst length: 8 (interleave without any limit, sequential with starting address ?000? only), 4 with tccd = 4 which does not allow seamless read or write [either on the fly using a12 or mrs] ? bi-directional differential data strobe ? thermal sensor grade b ? internal(self) calibration : internal self calibration through zq pin (rzq : 240 ohm 1%) ? on die termination using odt pin ? average refresh period 7.8us at lower than tcase 85c, 3.9us at 85c < tcase < 95c ? asynchronous reset ? pcb: height 1.18? (30mm), double sided component document no. valueram1336-001.a00 04/23/13 page 1 memory module speci cations continued >> specifications cl(idd) 9 cycles row cycle time (trcmin) 49.5ns (min.) refresh to active/refresh 260ns (min.) command time (trfcmin) row active time (trasmin) 36ns (min.) maximum operating power (1.35v) = 1.761 w* (1.50v) = 1.957 w* ul rating 94 v - 0 operating temperature 0 o c to 85 o c storage temperature -55 o c to +100 o c *power will vary depending on the sdram.
document no. valueram1336-001.a00 page 2
|
